ESP32 Credit Spammer Manager

CreditSpammer Web Installer

Plug your ESP32 via USB. Click Install and select the correct port. After flashing, you will be prompted for Wi‑Fi.

Install

Preparing installer…

Add New ESP32

Device Information

Device Name:

WiFi Configuration

Enter WiFi credentials to embed in firmware

WiFi SSID (Network Name): The name of your WiFi network

WiFi Password: Password for your WiFi network

Device Selection

Select the connected ESP32 device

Select Connected ESP32 Device: Plug in your ESP32 and select it from the list

Baud Rate:

Note: This will automatically generate firmware with default settings and upload it to your ESP32. You can adjust settings later, and they will update the device over WiFi.

Configure ESP32 Settings

Device Name:

Location: Group devices by location

Boot Delay (1 second - 99 minutes): Time in seconds before initial boot spam starts (1 second = 1, 1 minute = 60, 99 minutes = 5940)

Credit Count (1-999): Number of times to spam pin 2

Credit Delay (1-1000 ms): Delay between each spam

Credit Delay (1 second - 99 minutes): Time in seconds between initial boot and subsequent loops (1 second = 1, 1 minute = 60, 99 minutes = 5940)

Loop Count (0-999, 0 = infinite): Number of times to loop (0 = infinite)

Generate & Upload Firmware

WiFi Configuration

Enter your WiFi credentials to embed in the firmware

WiFi SSID (Network Name): The name of your WiFi network that the ESP32 will connect to

WiFi Password: The password for your WiFi network

Device Selection

Select the connected ESP32 device to upload firmware to

Select Connected ESP32 Device: Detected serial ports will appear here. Plug in your ESP32 and click refresh if you don't see it.

Baud Rate:

Note: The firmware will be generated with your WiFi credentials and device settings. For uploading, you'll need Arduino IDE installed (which will compile and upload automatically) or Arduino CLI with esptool.py for direct flashing.

Connect ESP32 via USB (Web Serial)

Requires Chrome/Edge over HTTPS. Click Connect and select your ESP32 COM port.

Idle

Flash ESP32 via Web Serial

Device Name

WiFi SSID

WiFi Password

Idle

Settings

▶

📍 Location Management

Add or remove location names for organizing ESP32 devices.

Add New Location:

Current Locations:

▶

🎨 Theme Colors

Customize the gradient colors for the page background.

Gradient Start Color:

The starting color of the gradient

Gradient End Color:

The ending color of the gradient

Preview: